Cummins 17kW Home Standby Generator 200 Amp Automatic Transfer Switch | Quiet Connect Series RS17A-NP2

Cummins 17kW Home Standby Generator 200 Amp Automatic Transfer Switch

Cummins 17-Kilowatt Standby Generator 200 Amp, Service-Entrance-Rated, NEMA 3R Indoor/Outdoor Automatic Transfer Switch supplies your entire home during an outage.

The Cummins 17kW Home Standby Generator 200 Amp Automatic Transfer Switch connects permanently to your house through the automatic transfer switch and runs on the existing natural gas or propane supply. It monitors the power company distribution lines 24/7, then automatically starts and runs when it detects an outage and continues to run until the utility restores power.

Note: The Fuel Inlet Connection location has Changed. Click the FAQ Tab for details.

Cummins Quiet Connect 17kW

The Cummins RA212SA3 200-Amp Automatic Transfer Switch with NEMA 3R Aluminum enclosure rated for indoor and outdoor use installs between the utility meter and the main circuit breaker panel. The generator controller automatically starts the generator within seconds after it detects an outage. After startup, it signals the transfer switch to isolate the home from the utility lines and supply it with power from the generator. It all happens automatically within seconds after an outage.

Powerful motor starting capability allows the Cummins 17kW Standby Generator to start a 5-ton air conditioner while operating a full household load and supply clean power to sensitive electronics at the same time. From a no-load condition to accepting a normal household load, the voltage varies by no more than 1.25 percent. Under steady-state conditions, the RS17A-NP2 maintains voltage within 1.25 percent and frequency never varies more than 1.25 percent. Clean, worry free power you can count on.

The Cummins 17kW Home Standby Generator 200-Amp Automatic Transfer Switch with Intelligent Load Management (**kit sold separately) learns and remembers the power requirements of 240-volt loads like air conditioners. Load management allows a smaller, more fuel-efficient generator to manage up to four central air conditioners or other heavy loads. The A051C329 Cummins Load Management Kit controls two appliances like an air conditioner or water water. Two kits can control four loads.

Monitor and control the Cummins Quiet Connect 17kW from almost anywhere. Advanced Remote Access (no cost) uses the highway safety and monitoring network for vehicles and equipment. Check generator status, program exercise periods, even manually start and stop the generator using the Cloud Connect Smartphone App on phones, tablets, or computers. Send performance data directly to your authorized dealer for worry-free maintenance.

A compact, efficient design packs the Cummins 17kW with 200amp Transfer Switch into a 34 x 36 x 27-inch enclosure. The generator meets NFPA 37 code for installation just 18-inches from the home. A sleek and attractive cabinet blends into the landscaping.

Patented sound technology and an advanced housing design with a corrosion resistant aluminum exterior and galvanized steel interior reduces noise and vibration. Sound levels of just 65dBA make the 17kW Standby Generator among the quietest in its class.

The Cummins 17kW with 200amp Transfer Switch comes equipped for operation down to zero degrees out of the box. Cold weather accessories extend the operating temperature well below zero for reliable starts across the northern continental United States.

A patented “Crank-Only” mode reduces wear and tear during the exercise cycle. The engine cranks without starting while the controller performs diagnostics. The Cummins Quiet Connect 17kW gets the exercise it needs, while the controller ensures that the generator is operating correctly. This eco-friendly feature saves fuel and produces less noise than operating the generator for 5 to 20 minutes every week.

Cummins’ QSJ999G Engine powers the Cummins 17kW Home Standby Generator 200-Amp Automatic Transfer Switch. Cummins, the world-class leader in diesel and natural gas engines, designed and built the propane or natural gas engine. The installer selects the fuel-type during installation.

Cummins 17kW with 200amp Transfer Switch

Cummins Power Generation supports the Cummins 17kW with 200amp Transfer Switch with the world’s largest and best trained worldwide network of certified distributors and dealers. They answer questions about maintenance and operation and offer a complete selection of maintenance parts, accessories, and products along with manuals and specification sheets.

The 17kW Standby Generator includes a five-year/2000-hour limited warranty that covers travel and labor for two years and parts for a full five years.

Make the Cummins 17kW with 200amp Transfer Switch installation easier with a Generator Pad. Required by some local building codes, they keep the generator from sinking into the dirt. Using a premade generator pad eliminates the need for a poured concrete base or a pea gravel bed.

Requires a Group 51R 450 CCA Battery purchased locally.

Product Specifications